Sat-Forum.Net

Hello,

I need the recovery firmware or original RAW dump for:

Receiver: TIGER ONE MILLION EYES V1
Board: FH26-2D4G-V1
Board date: 20210701
Flash chip: GD25Q32, 4 MB

The receiver is stuck on BOOT after a wrong 16 MB GD25Q128 dump was programmed by mistake.

I need either:
1. RECOVERY TIGER ONE MILLION-V1.01.bin compatible with GD25Q32, or
2. A complete original 4 MB RAW dump, exactly 4,194,304 bytes, from the same board.

Please do not send a 16 MB GD25Q128 dump or a firmware file unless it is confirmed compatible with this board.

Thanks for questions


Here is file program via flasher

[SHOW POST]

https://www.mediafire.com/file/aby4ryul ... R.zip/file

merci de votre reponse
Le transfert s'effectue-t-il via USB ou à l'aide du looder

RS232 flasher / Ali Upgrade Tool

Try with 232 if not work box

Then use programmer flash

SatEmpire wrote: ↑24 Oct 2026, 22:05 Thanks for questions


Here is file program via flasher

[SHOW POST]

https://www.mediafire.com/file/aby4ryul ... R.zip/file

Thank you for the files. My receiver stays at BOOT and UART reports "verify code signature failed". Ali Upgrade Tool remains at "Sending upgrade request to box...".

Are V4.73 and V4.76 intended for direct SPI programming, or must they be loaded through RS232 using the Tiger loader? Are they compatible with board FH26-2D4G-V1 (20210701)?

Thank you; the issue has been resolved and the device is working again. Thanks for your help

chaffari habib wrote: ↑Today, 14:58 Thank you; the issue has been resolved and the device is working again. Thanks for your help